Injector filters become clogged

-

CAUSE OF FAILURE 2..."Foreign particles" in fuel tank(s) or fuel lines, or fuel rail. Foreign particles in almost all instances, will be rust. Larger rust particles may be collected within the injector filter, or the fuel filter, and reduce fuel flow. Microscopic rust particles may also pass thru the injector filter, and cause the spray pattern to alter, fuel flow to alter, and/or the injector pintle to not seat properly. This is a common problem on vehicles that have sat unattended, or suffered from lack of routine maintenance. Incorrect fuel tank fuel filter; holes/tears in fuel tank fuel filter; breakdown/degradation of interior wall of fuel supply line; breakdown/degradation of interior wall of fuel injector hose, and rust in the fuel rail.

EFFECTS OF FAILURE 2...the injectors leak at the pintle and/or the spray pattern is altered, and/or the fuel flow is altered. Lack of engine power from underfueling; potential for engine overheating; remaining injectors/cylinders are overfueled to compensate for underfueled injectors/cylinders as the "closed loop" O2 system attempts to maintain stoiciometric ratio.

Comments

Post a Comment

Popular posts from this blog

Oil mist detectors

-
Image
There are two methods of oil mist detection, Obscuration and Light Scatter . The earlier forms of oil mist detector used an obscuration type detector, the most well known type being the early Graviners. Schaller use obscuration in their Visatron range of OMDs. Light scatter is a modern method of oil mist detection used by QMI and the Latest Graviner Mk6 OBSCURATION The older type of obscuration type of detector consists of two parallel tubes of equal size, each having a photoelectric cell at one end which generates an electric current directly proportional to the intensity of the light falling on its surface. Lenses are fitted to seal the ends of each tube but allow light to pass. Two identical beams of light from a common lamp are reflected by mirrors to pass along the tubes onto the cells which are then in electrical balance. The samples drawn from the crankcase are drawn in turn along the m
Read more

Crankcase relief valve testing

-
Image
FLAME ARRESTORS AND SHIELDING The intention of the requirement to shield the valve discharge was to reduce the possible danger to personnel from flame emission. However explosion testing has shown that whilst a flame arrestor will work satisfactorily when shielding is not fitted, when shielding is fitted, the energy from the discharge is focussed in one direction, and there will be an emission of flames during an explosion. The fitting of shielding also reduces the effective outflow area of a valve. Since July 2002 it has been a Lloyds Register rule requirement to fit flame arrestors and to test the relief valve with any proposed shielding to be fitted to the valve when installed on the engine. A test procedure for new crankcase relief valves has been developed over the past four years by MAN B&W, The Physical Test Institute in the Czech Republic , Hoerbiger, and various classification socie
Read more