Spring Tension

-

We test each and every spring for installed pressure and open pressure.

Comments

Post a Comment

Popular posts from this blog

Measure Indicated Power in Diesel Engine with Indicator Diagram

-
Image
The burning of fuel in an engine cylinder (2 stroke or 4 stroke diesel engine) will result in the production of power at an output shaft, some of the power produced in the cylinder will be used to drive the rotating masses of the engine. Typical indicator diagram for a 2 stroke engine is shown in figure below. The area within the diagram represents the work done within the cylinder in one cycle. The area can be measured by an instrument known as 'Planimeter' or by the use of the mid ordinates rule. [On modern engines this diagram can be continuously taken by employing two transducers, one pressure transducer in the combustion space and other transducer on the shaft. Through the computer we can thus get on line indicated diagram and power of all cylinders.] The area is then divided by the length of the diagram in order to obtain mean height. This mean height, when multiplied by the spring scale of the indicator mechanism, gives the indicated mean effective pressures for the cyli...
Read more

Crosshead

-
Image
The Crosshead The crosshead pin connects the piston rod to the connecting rod. On either side of the crosshead pin are mounted the crosshead slippers. The slippers run up and down in the crosshead guides as the piston and rod are reciprocating and prevent the top of the connecting rod from moving sideways. The crosshead pin sits in the crosshead bearing which is either a forked type (shown left), where the bearing housings are mounted on the top of the connecting rod either side of the piston rod, or of the continuous type (shown above and below), where the bearing housing is formed by the top of the connecting rod. On the forked type, the piston rod passes through a hole in the crosshead pin and is secured by a nut. On the continuous type, the piston rod has a foot which is bolted onto the top of the crosshead pin. Modern engines are fitted with the continuous type of bearing. The crosshead bearing is difficult to lubricate effectively. Because the top of the connecting rod s...
Read more

Fuel Pump

-
Image
Medium speed four stroke engines are equipped with jerk type fuel pumps, one for each cylinder. A plunger operated by a cam reciprocates in a barrel. The plunger has a helix machined into it which also forms a vertical groove and an annular groove at the base of the helix. The barrel is located in the pump body which has spill ports, connected to the suction side of the pump, drilled so that they are above the top of the plunger when the cam is on the base circle. The plunger is keyed to a sleeve which has a gearwheel (pinion) machined into it. The pinion meshes with a rack which can rotate the plunger relative to the barrel. The rack is connected to the engine governor. As the plunger moves upwards in the barrel, injection will commence once the plunger has closed off the spill ports and the pressure builds up. As soon as the helix or scroll passes the spill ports the pressure above the plunger will immediately drop, even though the...
Read more