Frames

-

Otherwise known as the A Frames. These carry the crosshead guides and support the engine entablature (the cylinder block). On large engines, the A frames are individually erected on the bedplate directly above the transverse girders. When boxed in with plating they form the crankcase. The trend nowadays is to build the frame box as a separate fabricated construction and then, after stress relieving and machining the mating surfaces, to mount it on the bedplate. This has the advantage of saving weight.

When the frames are aligned on the bed plate they are secured together by drilling and reaming and using fitted bolts.

Cracking in A frames can occur leading to misalignment and excessive wear of the running gear. Cracks can start from welds, sharp changes in section and where strengthening stringers are terminated sharply. Repairs can involve cutting the crack out, grinding and rewelding. The danger is that after repair there may still be misalignment.

Comments

Post a Comment

Popular posts from this blog

Oil mist detectors

-
Image
There are two methods of oil mist detection, Obscuration and Light Scatter . The earlier forms of oil mist detector used an obscuration type detector, the most well known type being the early Graviners. Schaller use obscuration in their Visatron range of OMDs. Light scatter is a modern method of oil mist detection used by QMI and the Latest Graviner Mk6 OBSCURATION The older type of obscuration type of detector consists of two parallel tubes of equal size, each having a photoelectric cell at one end which generates an electric current directly proportional to the intensity of the light falling on its surface. Lenses are fitted to seal the ends of each tube but allow light to pass. Two identical beams of light from a common lamp are reflected by mirrors to pass along the tubes onto the cells which are then in electrical balance. The samples drawn from the crankcase are drawn in turn along the m
Read more

Crankcase relief valve testing

-
Image
FLAME ARRESTORS AND SHIELDING The intention of the requirement to shield the valve discharge was to reduce the possible danger to personnel from flame emission. However explosion testing has shown that whilst a flame arrestor will work satisfactorily when shielding is not fitted, when shielding is fitted, the energy from the discharge is focussed in one direction, and there will be an emission of flames during an explosion. The fitting of shielding also reduces the effective outflow area of a valve. Since July 2002 it has been a Lloyds Register rule requirement to fit flame arrestors and to test the relief valve with any proposed shielding to be fitted to the valve when installed on the engine. A test procedure for new crankcase relief valves has been developed over the past four years by MAN B&W, The Physical Test Institute in the Czech Republic , Hoerbiger, and various classification socie
Read more