Engine Frame

-

The engine frame of a modern 4 stroke medium speed diesel can be produced as a single casting or fabricated from cast steel sections and steel plates welded together.

With this design, there is no separate bedplate, frame and entablature as with a 2 stroke slow speed engine.

The photograph shows the frame of an engine with the liners and crankshaft in place.

An alternative method of construction is shown opposite. A separate bedplate is bolted to an entablature which holds the underslung crankshaft.

Shown here is a partial cross section from a one piece medium speed engine frame. The Crankshaft is underslung, and it can be seen in this example that the load on the bearing caps is transferred back to the frame by the use of tie bolts. Note the use of the side tie bolts which locate the bearing cap, and prevent sideways movement.

Comments

Post a Comment

Popular posts from this blog

Oil mist detectors

-
Image
There are two methods of oil mist detection, Obscuration and Light Scatter . The earlier forms of oil mist detector used an obscuration type detector, the most well known type being the early Graviners. Schaller use obscuration in their Visatron range of OMDs. Light scatter is a modern method of oil mist detection used by QMI and the Latest Graviner Mk6 OBSCURATION The older type of obscuration type of detector consists of two parallel tubes of equal size, each having a photoelectric cell at one end which generates an electric current directly proportional to the intensity of the light falling on its surface. Lenses are fitted to seal the ends of each tube but allow light to pass. Two identical beams of light from a common lamp are reflected by mirrors to pass along the tubes onto the cells which are then in electrical balance. The samples drawn from the crankcase are drawn in turn along the m
Read more

Crankcase relief valve testing

-
Image
FLAME ARRESTORS AND SHIELDING The intention of the requirement to shield the valve discharge was to reduce the possible danger to personnel from flame emission. However explosion testing has shown that whilst a flame arrestor will work satisfactorily when shielding is not fitted, when shielding is fitted, the energy from the discharge is focussed in one direction, and there will be an emission of flames during an explosion. The fitting of shielding also reduces the effective outflow area of a valve. Since July 2002 it has been a Lloyds Register rule requirement to fit flame arrestors and to test the relief valve with any proposed shielding to be fitted to the valve when installed on the engine. A test procedure for new crankcase relief valves has been developed over the past four years by MAN B&W, The Physical Test Institute in the Czech Republic , Hoerbiger, and various classification socie
Read more