Con Rod

-
The Con Rod

The Connecting Rod is fitted between the crosshead and the crankshaft. It transmits the firing force, and together with the crankshaft converts the reciprocating motion to a rotary motion. Made from drop forged steel, on the older engines the bottom of the con rod terminates in a flange known as a Marine Palm which is bolted to the split bottom end (Crankpin) bearing, whilst at the top another flange is formed on which is bolted the two crosshead bearings.


Connecting Rods on the later engines are produced as a single drop forging incorporating the top half of the crankpin bearing housing and the bottom half of the solid crosshead pin bearing housing.

On older engines the bearings were white metal thick wall bearings, scraped to fit. Clearances were adjusted by inserting or removing shims between the bearing halves. Modern bearings are of the "thinwall" type, where a thin layer of white metal or a tin aluminium alloy is bonded to a steel shell backing. The clearance on these bearings is non adjustable; When the clearance reaches a maximum the bearing is changed.

Oil to lubricate the crankpin bearing is supplied down a drilling in the con rod from the crosshead. When inspecting the crankpin bearing and journal it is good practise to check the journal for ovality because if this is excessive, a failure in the hydrodynamic lubrication can occur.



Comments

Post a Comment

Popular posts from this blog

Oil mist detectors

-
Image
There are two methods of oil mist detection, Obscuration and Light Scatter . The earlier forms of oil mist detector used an obscuration type detector, the most well known type being the early Graviners. Schaller use obscuration in their Visatron range of OMDs. Light scatter is a modern method of oil mist detection used by QMI and the Latest Graviner Mk6 OBSCURATION The older type of obscuration type of detector consists of two parallel tubes of equal size, each having a photoelectric cell at one end which generates an electric current directly proportional to the intensity of the light falling on its surface. Lenses are fitted to seal the ends of each tube but allow light to pass. Two identical beams of light from a common lamp are reflected by mirrors to pass along the tubes onto the cells which are then in electrical balance. The samples drawn from the crankcase are drawn in turn along the m
Read more

Crankcase relief valve testing

-
Image
FLAME ARRESTORS AND SHIELDING The intention of the requirement to shield the valve discharge was to reduce the possible danger to personnel from flame emission. However explosion testing has shown that whilst a flame arrestor will work satisfactorily when shielding is not fitted, when shielding is fitted, the energy from the discharge is focussed in one direction, and there will be an emission of flames during an explosion. The fitting of shielding also reduces the effective outflow area of a valve. Since July 2002 it has been a Lloyds Register rule requirement to fit flame arrestors and to test the relief valve with any proposed shielding to be fitted to the valve when installed on the engine. A test procedure for new crankcase relief valves has been developed over the past four years by MAN B&W, The Physical Test Institute in the Czech Republic , Hoerbiger, and various classification socie
Read more